# Voltmeter MCQ

16. To increase the range of a voltmeter

1. A low resistance is connected in series
2. A low resistance is connected in series
3. A high resistance is connected in series
4. A high resistance is connected in parallel

17. Two voltmeters (0-300V) range are connected in parallel to a.c. circuit. One voltmeter is moving iron type reads 200V. If the other is PMMC instrument, its reading will be

1. Zero
2. 222 V
3. 127.4 V
4. Slightly less 200 V

18. The resistance of a voltmeter and ammeter is respectively

1. Low and high
2. High and high
3. High and low
4. Low and low

19. A voltmeter uses a meter with Ifs = 2 mA. Its sensitivity is

1. 500 ohm/V
2. 500 V/ohm
3. 2000 ohm/V
4. 2000 V/ohm

20. The accurate voltmeter must have a resistance of

1. Very low value
2. Low value
3. Very high value
4. None of these

21. To convert a galvanometer into a voltmeter, the value and type of connection of the resistance to be connected with should be

1. Low and parallel
2. High and parallel
3. Low and series
4. High and series

22. Which of the following voltmeters would you use for measuring the voltage across 20 kΩ resistance

1. Voltmeter having a resistance of 5 kΩ
2. Voltmeter having a sensitivity of 1 kΩ/V
3. Voltmeter having sensitivity of 10 kΩ/V
4. None of these

23. A voltmeter has a resistance of  2000 Ω when it is connected across a d.c. circuit its power consumption is 2 mW. Suppose this voltmeter is replaced by a voltmeter of 4000 Ω resistance, the power consumption will be

1. 4 mW
2. 1 mW
3. 2 mW
4. None of these

24. A voltmeter must have a very internal resistance so that the

1. Accuracy is high
2. Resolution is high
3. Meter draws minimum current

25. The most basic of all instrument is

1. The current meter
2. The voltmeter
3. The multimeter
4. The oscilloscope

26. In a 3½ digital voltmeter, the largest number that can be read is

1. 999
2. 1999
3. 4999
4. 9999

27. An accurate voltmeter  must have an internal impedance of

1. Very low value
2. Low value
3. Very high value
4. Zero

28. When the DC voltmeter is connected polarities reversed

1. The pointer deflects upscale
2. The pointer deflects downscale
3. The pointer remains stationary
4. None

29. Voltmeter sensitivity is defined by

1. Volt/ohm
2. Volt/ohm2
3. Ohm/volt
4. Ohm/volt2

30. For a 1000 micro amp movement with 100 Ω Rm, its voltage Vm at full-scale deflection is

1. 250 micro volt
2. 0.1 Volt
3. 0.2 Volt
4. 0.5 Volt