# Governor MCQ

1. Function of a governor is to

1. control the engine speed
2. maintain the speed of engine constant
3. store energy and give up whenever required
4. adjust variation of speed by varying the input to the engine

2. Governor basically works to

1. control the speed
2. control the fuel supply
3. control fuel according to engine load
4. none of above

3. The governor is said to be unstable when the radius of rotation of balls __________ as the equilibrium speed increases.

1. increases
2. decreases
3. remain constant
4. fluctuate

4. A porter governor is a/an

1. pendulum-type governor
4. inertia governor

5. The governor which has two arms fixed on extension of arms is

1. Watt governor
2. Porter governor
3. Hartnell governor
4. Proell governor

6. If the stiffness of spring is increased the Hartnell governor will become

1. Hunting
2. Isochronous
3. More sensitive
4. less sensitive

7. The isochronism is a stage of

1. infinite sensitivity
2. infinite stability
3. zero stability
4. zero sensitivity

8. If ω1 is minimum angular speed, ω2 is maximum angular speed and ωm is the mean angular speed, then the sensitiveness of a governor is given by,

1. ωm/(ω2 – ω1)
2. 2 – ω1)/ωm
3. 2 – ω1)/2ωm
4. 2(ω2 – ω1)/ωm

9. When the pitching of a ship is upward, the effect of gyroscopic action on it will be

1. To move the ship towards star-board
2. To move the ship towards port side
3. To raise the stern and lower the bow
4. To raise the bow and lower the stern

10. Governor is used in automobile to

1. decrease the variation of speed
2. control δN/δt
3. control δN
4. all of the above

11. When the speed of the engine fluctuates continuously above and below the mean speed, then the governor is said to be

1. stable
2. unstable
3. isochronous
4. hunt

12. When the sleeve of a Porter governor moves upwards, the governor speed

1. increases
2. decreases
3. remains unaffected
4. none of these

13. The Porter governor is an example of

1. Inertia governor
2. Flywheel governor
3. Centrifugal governor
4. None of these

14. In a watt governor, the weight of the ball is 50 N and the friction at the sleeve is 10 N. The coefficient of detention would be

1. 0.5
2. 5.0
3. 0.1
4. 0.2

15. When the load on engine increases, it becomes necessary to increase the supply of the working fluid and when the load decreases, less working fluid is required. The supply of the working fluid to the engine is controlled by a

1. Governor
2. D-slide valve
3. Flywheel
4. Meyer’s expansion valve

16. What would be the vertical height of a watt governor when it rotates at 60 r.p.m?

1. 0.91 m
2. 1.5 m
3. 2 m
4. 0.24 m

17. Which of the following relation is CORRECT about the controlling force (F) for a spring controlled governor to be stable?

1. F = ar – b
2. F = ar + b
3. F = a/r + b
4. F = ar

18. The sensitivity of an isochronous governor is

1. zero
2. one
3. two
4. infinity

19. A Hartnell governor comes under which type of governor?

1. Pendulum type
2. Inertia type
3. Centrifugal type